Painting and customizing Gundam Kits

Hello everybody!! Changing a bit the kind of blog post, I will now show a little as I have to apply some different colors in the kits I bought.

First, the use of Spray:

I found some videos on youtube very good spray paint, but one in particular was very helpful to me and it is this "technique" that will show.

materials:

- A4;

- Spray (óbvio. ..)

- Double-sided tape;

Place the tape on the paper and fold the corners of the paper up and easy handling ...

Then place the pieces you intend to paint stuck to the tape. Note that this technique is only for parts that do not need to be painted on all sides, as there is no face paint that is attached to is (usually the inner side, so no problem).

one so, use the spray!! Remember to keep a distance of about 30 cm to avoid soaking the piece and lose detail. Use also a cool place because steam ink ... One or two coats should be sufficient if it is really necessary to apply a third maximum. Allow to dry and the result will be great!

Note:

If the part you are handling need to be painted on all sides. Use a toothpick or clip with which you can hold it while applying the spray. Turn it slowly in each inkjet until all of it is covered. Then put the toothpick in a loca firm to dry.

Remember to protect connectors, as paint can make them look more thick and hamper the assembly later.

Ah! The video I said was that the Gundam UK:

http://www.youtube.com/watch?v=lxQoiLxxDac&list=TLhFHXka03XRIemwMJtm3_rKdz67pMw4Ja

Hope you enjoy! Until next time!